![]() Restart the SNMP service which will also restart all of the HP management agents. Ensure that traps sent from the localhost are allowed to be received. On the Security tab enter the community name you just created in the accepted community names box and set its permissions to READ WRITE. Make sure that the loopback address is added to the trap destinations area. On the Traps tab enter a community name of your choosing, the typical names are “public” and “private”, public being read-only and private being read-write. 27, HP ProLiant iLO 2 Management Controller Driver for Windows Server 2012 v1. HP ProLiant Smart Array SAS/SATA Controller Driver for Windows Server 2008 圆4. First ensure that the SNMP service is installed then open it’s properties. Select the HP USB Key Utility shortcut in the HP System Tools folder. How can I tell if my Windows operating system is 32-bit or 64-bit. Even if you don’t have an enterprise SNMP trap receiver you need to configure the service on the local server to send updates to itself, at least. This is because the Management Homepage relies on SNMP which is either not installed or not configured properly. If you’ve installed the Proliant Support Pack (8.x) after the fact, or built a new server with SmartStart and did not enable SNMP then you’ve probably seen this after the install:Īll of the HP agents are started and reporting “all is well” but no specific component information is displayed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |